I
INCH-PO
ml
GGG-W-648B
30.
1992
SUPSRSEDINC
GGG-U-648a
November 25, 1966
FEDSRAL SPECIFICATION
WRENCH , LINENAN’S
This specification is approved by the Commissioner, Federal
Supply Service, General Services Administration, for the use
of all Federal agencies.
1. SCOPE AND CLASSIFICATION
1.1 u.
This specification covers lineman’s wrenches used in poleline
work.
The wrenches vere formerly covered by CGG-W-66fI.
1.2 Clnssifi
cflciOQ.
1.2.1 ~vue and sizee. Wrenches shall be of the lineman’s type and of the
following sizes, as specified (see 6.2 and 6.3) :
5/8 - (See table I)
3/6 - (See table 1)
2. APPLICABLE 00CUMENTS
2.1. $Decif icncions and scandnrds. The following specifications and
standards form u part of this documenc
to the extent specified herein. Unless
otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DODISS) and
supplement thereto, cited in che solicitation (see 6.2) .
Federal Standards
FED-STD-123 - Marking for Domestic Shipment (Civil Agencies)
IBeneficinl comments (recommendations, nddit ions,
deletions) and any pertinent I
Idata which may be of use in improving this document should be sddressed to: 1
ICommanding Officer (Code 156), Naval Construction Battalion Centar, Port [
lHueneme, CA 93043-5000, by using the Standardization Document Improvement 1
IProDosal (DD Form 1
626) avvenring at
ch
e end of
this
docwnent or bv letter.
I
FSC 5120
DISTRIBUTION
STATEU
ENT A. Approved for public release: distribution is
unlimited.
Downloaded from http://www.everyspec.com
