INCH-POUND
HH-G-156E
5 April 1993
SUPERSEDING
HH-G-156d
September 25, 1967
(See 6.5)
FEDERAL SPECIFICATION
GASKET MATERIAL, GENERAL PURPOSE; RUBBER SHEETS,
STRIPS, AND SPECIAL SHAPES
This specification is approved by the Commissioner, Federal Supply Service,
General Services Administration, for the use of all Federal agencies.
1. SCOPE AND CLASSIFICATION
1.1 Scope. This specification covers material for general purpose
rubber gaskets and packing except those for shipboard hatches, airports,
watertight and airtight doors.
1.2 Classification. Gaskets covered by this specification shall be of the
following types, as specified (see 6.2):
Type I - Soft (nominally 40 Shore A durometer).
Type II - Medium (nominally 55 Shore A durometer).
Type III - Hard (nominally 80 Shore A durometer).
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications and standards. The following specifications and
standards form a part of this document to the extent specified herein.
Unless otherwise specified, the issues of these documents are those listed in
the issue of the Department of Defense Index of Specifications and Standards
(DODISS) and supplement thereto, cited in the solicitation (see 6.2).
ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
³ Beneficial comments (recommendations, additions, deletions) and any ³
³ pertinent data which may be of use in improving this document should ³
³ be addressed to: Commander, SEA 05Q42, Naval Sea Systems Command, 2531 ³
³ Jefferson Davis Hwy., Arlington, VA 22242-5160 by using the ³
³ Standardization Document Improvement Proposal (DD Form 1426) appearing ³
³ at the end of this document or by letter. ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
AMSC N/A FSC 5330
DISTRIBUTION STATEMENT A. Approved for public release;distribution is
unlimited.
Downloaded from http://www.everyspec.com
