I
1’
EEEiEil
J-w-1177/13B
June 10,
1988
SUPERSEDING
●
I
●
J-w-1177/13A
September 27, 1976
FEDERAL SPECIFICATION SHEET
WIRE, MAGNET, ELECTRICAL , CLASS 200, TYPE K,
POLYESTER , POLYESTER-IMIDE OR POLYESTER-AMIDE-IMIDE OVERCOATED
WITH POLYANIDE-IMIDE , RECTANGULAR
This specification Is approved by the Commissioner, Federal Supply Service,
General Services Administration, for the use of all Federal agencies.
The requirements for acquiring the wire described herein shall consist of this
specification and the latest issue of J-W-1 177.
Classification:
Class 200; type K2 (heavy), type K4 (quadruple);
rectangular.
Insulating msteriala:
The conductor shall be coated with a dual film. The
underlying coating shall be based on a polyester,
polyester-imide or a polyester-amide-imide resin.
The superimposed coating shall be based on a
polyamide-imide resin.
NENA/ANSI equivalent: All test requirements except thermal endurance
are equivalent to MW-36 or NEMA NW 1000.
General requirements:
See J-W-1177 for general requirements, quality
assurance provisions, and packaging.
Requirements:
Teat procedure,
Wire aizea,
CharaCteri6ti C6 see J-W-1177
AwG Requirement!
Dimensions
o
AMSC N/A
DISTRIBUTION STATENENT A
4.7.1.2
All
Rectangular wire:
(a) Conductor dimensions
and radii - aee
table I.
(b) Conductor tolerant,, -
see table II.
(c) Increase in thickness
and width - see table
III.
Square wire:
(a) Conductor dimensions,
radii and tolerance -
see table IV.
(b) Increaae in thickness
and width - see table
IV.
FSC 6145
Approved for public release; distribution unlimited
lof6
Downloaded from http://www.everyspec.com
