.
J-W-1177/37
June 10, 1988
FEDERAL SPECIFICATION SHEET
WIRE, MAGNET, ELECTRICAL, CLASS 130, TYPE SP,
SOLDERABLE POLYURETHANE, ROUND
- -
.—
..-.
-.
-
This specification is approved by the Commissioner, Federal Supply Service,
General Services Administration,
for the use of all Federal agencies.
The requirements for acquiring the wire described herein shall consist of this
specification and the latest issue of J-W-1177.
Classification:
Class 130; type SP (single) type SP2 (heavy); round.
insulating materials:
The film shall be based on a solderable polyurethane “-
reg.in.
NEMA/ANSI equivalent:
All test requirements except thermal endurance are
equivalent to MW-75 of NEM.AMW 1000.
General requirements:
See J-W-1177 for general requirements, quality
assurance provisions, and packaging.
Requirements:
w
Test procedure,
Ch,zracteristics
see J-W-1177
Dimensions
4.7.1.2
Adherence and
4.7.2.1
flexibility
Elongation
4.7.5
Heat shock
4.7.4
Scrape r~sistance
4.7.6
Wire sizes,
AWG
25-56
25-56
25-50
25-44
25-30
Requirements
See table I.
No cracks visible in the film
coating.
Not less than the value in
table II.
No cracks visible in the
coating after conditioning
as shown in table III.
Lowest grams-to-fail load for
any of the three tests anc
the average of the three
tests shall be not less than
the values in table IV.
AMC N/A
FSC 6145
DISTRIBUTION STATEMENT A Approved for public release; distribution unlimited
lof7
Downloaded from http://www.everyspec.com
