*------------*
* INCH-POUND *
*------------*
KKK-E-2808
December 30, 1992
-----------------
SUPERSEDING
MIL-E-22901F
30 April 1986
FEDERAL SPECIFICATION
EXCAVATOR, MULTIPURPOSE, TRUCK MOUNTED, TWO CABS
This specification is approved by the Commissioner, Federal
Supply Service, General Services Administration, for the use
of all Federal agencies.
1. SCOPE
1.1 Scope. This specification covers a truck mounted, two cab, two diesel
engine, telescoping boom type multipurpose excavator.
1.2 Classification. The excavator shall be one of the following sizes and
classes as specified (see 6.2):
Size 1 - Lifting capacity (with bucket) not less than 5,100 pounds (lb)
at 15 foot (ft) radius, bucket at ground level, measured by
SAE J1097
Size 2 - Lifting capacity (with bucket) not less than 6,650 lb at 15 ft
radius, bucket at ground level, measured by SAE J1097
Class B - 6 by 4 (3 axles, rear tandem axle driven)
Class C - 6 by 6 (3 axles, rear tandem, all wheel drive)
*-----------------------------------------------------------------------------*
*Beneficial comments (recommendations, additions, deletions) and any pertinent*
*data which may be of use in improving this document should be addressed to: *
*Commanding Officer (Code 156), Naval Construction Battalion Center, *
*621 Pleasant Valley Road, Port Hueneme, CA 93043-4300, by using the *
*Standardization Document Improvement Proposal (DD Form 1426) appearing at *
*the end of this document or by letter. *
*-----------------------------------------------------------------------------*
FSC 3805
DISTRIBUTION STATEMENT A. Approved for public release; distribution is
unlimited.
Downloaded from http://www.everyspec.com
