MIL-DTL-85J
28 March 2006
SUPERSEDING
MIL-DTL-85H
20 November 1998
DETAIL SPECIFICATION
WAVEGUIDES, RIGID, RECTANGULAR
GENERAL SPECIFICATION FOR
This specification is approved for use by all Depart-
ments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope
. This specification covers the performance requirements for seamless or fabricated rigid waveguides with rectangular
inside configurations (see 6.1).
2. APPLICABLE DOCUMENTS
2.1 General
. The documents listed in this section are specified in sections 3, 4 or 5 of this specification. This section does not
include documents cited in other sections of this specification or recommended for additional information or as examples. While
every effort has been made to ensure the completeness of this list, document users are cautioned that they must meet all specified
requirements documents cited in sections 3, 4 or 5 of this specification, whether or not they are listed.
2.2 Government documents
.
2.2.1 Standards
. The following standards form a part of this document to the extent specified herein. Unless otherwise specified,
the issues of these documents are those listed in the issue of the Department of Defense Index of Specifications and Standards
(DODISS) and supplement thereto, cited in the solicitation (see 6.2).
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-202 - Electronic and Electrical Component Parts.
MIL-STD-1285 - Marking of Electrical and Electronic Parts.
(Copies of the above specifications, standards, and handbooks are available from the Standardization Document Order Desk, 700
Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094; or at http://assist.daps.dla.mil
.)
2.3 Non-Government publications
. The following documents form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those cited in the solicitation or contract (see 6.2).
ASTM INTERNATIONAL
ASTM-B107/107M - Magnesium-Alloy Extruded Bars, Rods, Shapes, Tubes and wire (DoD adopted).
ASTM-B210 - Aluminum and Aluminum-Alloy Drawn Seamless Tubes and Wire (DoD adopted).
ASTM-B372 - Copper and Copper-Alloy Seamless Rectangular Waveguide Tube (DoD adopted).
Comments, suggestions, or questions on this document should be addressed to: Defense Supply Center Columbus, Code DSCC-
VAT, P. O. Box 3990, Columbus, OH 43218-3990 or emailed to TubesAmps@dscc.dla.mil
. Since contact information can change, you
may want to verify the currency of this address information using the ASSIST Online database at http://assist.daps.dla.mil/
.
AMSC N/A FSC 5985
INCH-POUND
Downloaded from http://www.everyspec.com
