INCH-POUND
MIL-DTL-287H
28 September 2007
SUPERSEDING
MIL-DTL-287G
20 October 2004
DETAIL SPECIFICATION
WAVEGUIDE ASSEMBLIES, FLEXIBLE, TWISTABLE AND
NON-TWISTABLE, GENERAL SPECIFICATION FOR
This specification is approved for use by all Depart-
ments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope
. This specification covers the general requirements for twistable and non-twistable, flexible waveguide
assemblies (hereinafter referred to as “assemblies”) (see 6.1).
1.2 Classification
. Assemblies consist of the following classes, as specified (see 3.1 and 6.5.1):
Class
Performance characteristics
1 - Twistable (mates with rigid rectangular waveguide components).
2 - Non-twistable (mates with rigid rectangular waveguide components).
3 - Extra-flexible, twistable (mates with rigid rectangular waveguide components).
1.2.1 Part or Identifying Number (PIN)
. The military PIN consists of the letter “M” followed by the basic number of the
specification sheet, an assigned dash number (see 3.1), and a coded four-digit number indicating the length.
Example: M287/1-01-0071 M287/1 01 0071
Military designator and specification sheet number
Dash number designated on specification sheet
Length (in inches) (see NOTE)
M287/1
01
0071
NOTE: The four digits indicate the nominal relaxed length of the assembly based on the requirements of 3.4.4.
Example: “-0071” is the number used to identify a length of 7.50 inches (190.5 mm).
2. APPLICABLE DOCUMENTS
2.1 General
. The documents listed in this section are specified in sections 3, 4,or 5 of this specification. This section
does not include documents cited in other sections of this specification or recommended for additional information or as
examples. While every effort has been made to ensure completeness of this list, document users are cautioned they must
meet all specified requirements documents cited in sections 3, 4, or 5 of this specification, whether or not they are listed.
2.2 Government documents
.
2.2.1 Specifications and standards
. The following specification and standard form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue of the Department
of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
COMMERCIAL ITEM DESCRIPTIONS
A-A-59588 - Rubber, Silicone.
Comments, suggestions, or questions on this document should be addressed to: Defense Supply Center Columbus, Attn:
Code DSCC-VAT, P. O. Box 3990, Columbus, OH 43218-3990 or e-mailed to TubesAmps@dscc.dla.mil
. Since contact
information can change, you may want to verify the currency of this address information using the ASSIST Online
database at http://assist.daps.dla.mil
/.
AMSC N/A FSC 5985
Downloaded from http://www.everyspec.com
