Beneficial comments (recommendations, additions, deletions) and any pertinent data that may be
of use in improving this document should be addressed to: Defense Supply Center Richmond,
ATTN: DSCR-VBD, Richmond, VA 23297-5610, by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter
.
AMSC N/A FSC 1560
DISTRIBUTION STATEMENT A
. Approved for public release; distribution is unlimited
.
INCH-POUND
MIL-DTL-781G
5 November 2001
SUPERSEDING
MIL-DTL-781F
30 October 1999
DETAIL SPECIFICATION
TERMINAL; WIRE ROPE SWAGING
This specification is approved for use by all Departments and Agencies of the Department
of Defense.
1. SCOPE
1.1 Scope
. This specification covers wire rope terminals designed for attachment to wire
rope by swaging.
1.2 Classification
. The terminals will be of the following types, as specified (see 6.2).
1.2.1 Types
. The types of terminals are as follows:
Type I - Straight shank terminals
Type II - Ball-end terminals
2. APPLICABLE DOCUMENTS
2.1 General
. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of the documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
*
*
*
Downloaded from http://www.everyspec.com
