MIL-DTL-001298D (AR)
30 March 2007
USED IN LIEU OF
MIL-G-1298A
10 OCTOBER 1955
DETAIL SPECIFICATION
GUN, MACHINE; CALIBER .50, BROWNING, M2, HEAVY BARREL
This specification is approved for use by the U.S. Army Armaments Research,
Development and Engineering Center (ARDEC), and is available for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope
. This detail specification prescribes the requirements and identifies the
verification procedures for the gun, machine, caliber .50, browning, M2, heavy barrel, hereafter
referred to simply as the M2.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2 Government documents
.
2.2.1 Specifications, standards, and handbooks. The following specifications,
standards, and handbooks form a part of this document to the extent specified herein. Unless
otherwise specified, the issues of these documents are those cited in the solicitation or contract.
AMSC N/A FSC 1005
DISTRIBUTION STATEMENT A. Approved for public release, distribution is unlimited.
INCH-POUND
Comments, suggestions, or questions on this document should be addressed to Commander ARDEC,
ATTN: AMSRD-AAR-QES-E, Picatinny, NJ 07806-5000) or emailed to (ardec-stdzn@pica.army.mil
).
Since contact information can change, you may want to verify the currency of this address information
using the ASSIST Online database at http://assist.daps.dla.mil
.
Downloaded from http://www.everyspec.com
