Comments, suggestions, or questions on this document should be addressed to Defense Supply
Center Richmond, ATTN: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-
5616 or e-mailed to STDZNMGT@dla.mil
. Since contact information can change, you may
want to verify the currency of this address information using the ASSIST database at
http://assist.daps.dla.mil/
.
AMSC N/A FSC 5365
INCH-POUND
MIL-DTL-3390G
19 November 2007
SUPERSEDING
MIL-R-3390F
8 September 1988
DETAIL SPECIFICATION
RINGS, DEE
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification covers dee rings for use on various equipage items (see 6.1).
1.2 Classification. The dee rings shall be of the configurations shown by letter
designations on Drawing 4-1-454 or 4-1-455, as specified (see 6.2) and shall be of the following
classes and sizes for the configuration shown. Configuration X shall be style 1 (without roller)
or style 2 (with roller) as specified (see 6.2).
1.2.1 Classes
. Classes of dee rings shall be as follows (see 6.1) and as specified (see
6.2):
Class 1 - Brass
Class 2 - Steel wire
Class 3 - Malleable iron
Class 4 - Nickel-silver alloy
Class 5 - Molding plastic (nylon) rigid
1.2.2 Sizes
. Configurations A, D, K, L, W, and X are available in various sizes as shown
on Drawing 4-1-454 and as specified (see 6.2).
Reactivated after 19 November 2007 and may be used for
new and existing designs and acquisitions.
Downloaded from http://www.everyspec.com
