1
NOT MEASUREMENT SENSITIVE
MIL-DTL-3476J
21 October 1998
SUPERSEDING
MIL-B-3476H
10 May 1991
DETAIL SPECIFICATION
BRASSARDS, GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and Agencies
of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the general requirements for brassards used by the
Department of Defense (see 6.1).
1.2 Classification. Brassards covered by this specification shall be as specified on the
applicable military specification sheet and Supplement 1 (see 2.1 and 6.2).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they
must meet all specified requirements documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards
and handbooks form a part of this document to the extent specified herein. Unless otherwise
specified, the issues of these documents are those listed in the issue of the Department of
Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the
solicitation (see 6.2).
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in preparing this document should be addressed to: Director, The Institute of
Heraldry, US Army, 9325 Gunston Road, Room S112, Fort Belvoir, VA 22060-5579, by using
the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of
this document.
AMSC N/A FSC 8455
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
Downloaded from http://www.everyspec.com
