MIL-DTL-3922C
6 March 2000
SUPERSEEDING
MIL-F-3922B
20 September 1963
DETAIL SPECIFICATION
FLANGES, WAVEGUIDE, GENERAL PURPOSE,
GENERAL SPECIFICATION FOR
This specification is approved for use by all depart-
ments and agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the general requirements for general purpose waveguide flanges that are used to
couple mechanically and electrically two sections of waveguides or waveguide parts (see 6.2).
1.2 Classification.
1.2.1 Type designation. The type designation of waveguide flanges is derived from the AN nomenclature system
specified in MIL-STD-196 and from the Part or Identifying Number (PIN) (see 3.1, 6.1 and 6.3).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This section
does not include documents cited in other sections of this specification or recommended for additional information or as
examples. While every effort has been made to ensure the completeness of this list, document users are cautioned that
they must meet all specified requirements cited in sections 3 and 4 of this specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, Standards and Handbooks. The following specifications, standards and handbooks form a part of
this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed
in the issue of the Department of Defense Index of Specifications and Standards (DODISS) and supplement thereto, cited
in the solicitation (see 6.2).
SPECIFICATIONS
FEDERAL
FF-S-85 - Screw, Cap, Slotted and Hexagon Head.
FF-S-86 - Screw, Cap, Socket Head.
FF-W-84 - Washers, Lock (Spring).
STANDARDS
FEDERAL
FED-STD-H28 - Screw-Thread Standards for Federal Services.
DEPARTMENT OF DEFENSE
MIL-STD-130 - Identification Marking of U.S. Military Property.
MIL-STD-196 - Joint Electronics Type Designation System.
(See Supplement 1 for applicable detail specifications.)
Beneficial comments (recommendations, additions, deletions) and pertinent data for improving this document should be
addressed to: Defense Supply Center Columbus, Attn: DSCC-VAT, P.O. Box 3990, Columbus, OH 43216-5000, by
using the Standardization Document Improvement Proposal (DD Form 1426) at the end of this document or by letter.
AMSC N/A FSC 5985
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
INCH-POUND
Downloaded from http://www.everyspec.com
