AMSC N/A FSC 5985
MIL-DTL-3922D
24 May 2011
SUPERSEDING
MIL-DTL-3922C
6 March 2000
DETAIL SPECIFICATION
FLANGES, WAVEGUIDE, GENERAL PURPOSE,
GENERAL SPECIFICATION FOR
This specification is approved for use by all departments
and agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the general requirements for general purpose waveguide flanges that are
used to couple mechanically and electrically two sections of waveguides or waveguide parts (see
6.2).
1.2 Classification.
1.2.1 Type designation. The type designation of waveguide flanges is derived from the AN nomenclature system
specified in MIL-STD-196 and from the Part or Identifying Number (PIN) (see 1.3).
1.3 Part or Identifying Number (PIN). The PIN for flanges covered by this specification consists of the letter M
followed by the basic number of the specification sheet and an assigned dash number (see
3.1).
M 3922/XX - XXX
Military designator Dash number
and specification sheet number designated
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards and handbooks. The following specifications, standards and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
cited in the solicitation or contract (see
6.2).
FEDERAL SPECIFICATIONS
FF-S-85 - Screw, Cap, Slotted and Hexagon Head.
FF-S-86 - Screw, Cap, Socket-Head.
FF-W-84 - Washers, Lock (Spring) (inactive for new design).
FEDERAL STANDARDS
FED-STD-H28 - Screw-Thread Standards for Federal Services.
Comments, suggestions, or questions on this document should be addressed to DLA Land and Maritime,
ATTN: VAT, P.O. Box 3990, Columbus, OH 43218-3990 or e-mailed to
TubesAmps@dla.mil. Since contact
information can change, you may want to verify the currency of address information using the ASSIST Online
database at https://assist.daps.dla.mil.
INCH-POUND
Downloaded from http://www.everyspec.com
