INCH-POUND
MIL-P-5673D
1 Februarv
1994
SUPERSEDING
MIL-P-5673C
31 January 1983
MILITARY SPECIFICATION
PIN, STRAIGHT, HEADED
This specification is approved for use by all
Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 m.
the
manufacture and
This specification establishes the requirements for
inspection of one type of straight headed pin.
1.2 Classification.
Pins shall be fabricated from any one of the
following compositions (see 3.1):
a.
4037, 4130 or 8630, steel alloy.
b. PH13-8M0, COrrOsiOn reSistant steel (Cres).
c. Ti-6Al-4v, titanium alloy.
d. 8740 steel alloy.
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications,
standards and handbooks.
Unless otherwise
-.
specified,
the following specifications, standards and handbooks of the
issue listed in that issue of the Department of Defense Index of
Specifications
and Standards (DODISS) specified in the solicitation
form a part of this specification to the extent specified herein.
Beneficial comments, (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document should be
addressed to the Naval Air Engineering Center, Engineering
.specifications and Standards Department (COde 93), Lakehurst, NJ
08733, by using the self-addressed Standardization Document Improvement
Proposal (DD Form 1426) appearing at the end of this document or
letter.
AMSC N/A
FSC 5315
DISTRIBUTION STATEMENT A.
Approved for public release; distribution is
unlimited.
Downloaded from http://www.everyspec.com
