DATA ITEM DESCRIPTION
Title: DEPARTMENT OF DEFENSE (DoD) MANUFACTURING PROCESS
STANDARD DOCUMENTS
Number: DI-SDMP-81476A Approval Date: 1 August 2003
AMSC Number: D7510 Limitation: N/A
DTIC Applicable: No GIDEP Applicable: No
Office of Primary Responsibility: OSD-SO
Applicable Forms: N/A
Use, Relationships: A DoD Manufacturing Process Standard will be used to state the desired
outcome of manufacturing processes or specify procedures or criteria on how to perform
manufacturing processes.
This Data Item Description contains the content and format preparation instructions for DoD
Manufacturing Process standards and their associated documents that are described in the
following paragraphs of MIL-STD-962D. Only those documents listed below will be required
when specified individually on contract.
a. DoD Manufacturing Process Standard – Paragraphs 4.1 through 5.15.
b. DoD Manufacturing Process Standard Revision – Paragraph 5.17.
c. DoD Manufacturing Process Standard Change – Paragraphs 5.18 through 5.18.7.
d. DoD Manufacturing Process Standard Inactive for New Design Notice – Paragraph
5.19.2.
e. DoD Manufacturing Process Standard Cancellation Notice – Paragraph 5.19.3.
f. DoD Manufacturing Process Standard Reinstatement Notice – Paragraph 5.19.4.
g. DoD Manufacturing Process Standard Reactivation Notice – Paragraph 5.19.5.
h. DoD Manufacturing Process Standard Administrative Notice – Paragraph 5.19.6.
This DID supersedes DI-SDMP-81476.
Requirements:
1. Reference documents.
The applicable issue of the documents cited herein, including their
dates and dates of any applicable notices and revisions, shall be as specified in the contract.
2. Format and content.
Format and content for DoD Manufacturing Process Standards shall be
as follows:
a. DoD Manufacturing Process Standard
. Format and content of DoD Manufacturing
Process Standards shall be in accordance with MIL-STD-962, paragraphs 4.1 through 5.15.
b. DoD Manufacturing Process Standard Revision
. Format and content of DoD
Manufacturing Process Standard Revisions shall be in accordance with MIL-STD-962,
paragraph 5.17.
Downloaded from http://www.everyspec.com
