CHANGE NOTICES ARE NOT Cumulative
●
AND SHALL BE RETAINED UNTIL THE
STANDARD IS REVfSED.
FED-STD-3 13D
CHANGE NOTICE 1
March 21,2000
FEDERAL STANDARD
MATERfAL SAFETY DATA, TRANSPORTATION DATA, AND DISPOSAL DATA
FOR HAZARDOUS MATERfALS FURNISHED TO GOVERNMENT ACTfVITIES
The following changes, which form a partofFED-STD-313D, dated April 3, 1996, are approved
by the General Services Administration for use by all federal agencies.
Section 2. After the ordering instructions for the Code of Federal Regulations (CFR), add the
following: CFRS are also available via the intemet at www.access.mso.~ov/nadcfr/cfr-table-
seareh.hrml A Toxic Release Inventory (TN) chemical list (EPA 745/K-94-052) is available
fkomthe EPCRA Document Distribution Center, I I029 Kenwood Road, Cincinnati, OH.45242,
Attention NCEP1, or on the Internet at www.errs.gov/ormtintr/tri/chemical.htm
Section 2. After the US Air Force Joint Manual, delete the intemet address and substitute the
following: www.afmc-mil.woafb.af.mil/Haznat/
3.2.2 Delete “(40 CFR Part 370)”, and substitute “(40 CFR ParI 302)”.
●
Section 3. Add the following new paragraph:
3.3 Preparer. The preparer is the entity that developed the MSDS and has provided the mailing
address and phone number for contacting the manufacturer, and the emergency response phone
number. The preparer may or may not be the contractor finishing the material to the
government. The preparer is responsible for the accuracy of the technical data in the MSDS.
4.2. I Add the”following: An MSDS is only required for a hazardous material incorporated into
an end item when that incorporation does not eliminate the material’s hazardous nature
throughout the life cycle of the end item.
4.2.2 Delete the tex~ and substitute the following: Prepamtion of the MSDS. The MSDS shall
meet afl requirements of 29 CFR 1910.1200. MSDSS in the 16-part format of ANSI Z400.1 are
preferred, but not required. MSDS preparm must indicate when the MSDS is available in
languages other than English. Information required under paragraph 4.3 must also be provided.
Contractors who have not manufactured the haznrdous material they are fimtishing to the
government, may append the goverrunent identifiers specified in 4.3.1,4.3.2, and 4.3.3 to the
preparer’s MSDS, provided the MSDS meets all other requirements of this standard. Contractors
RETAIN THIS NOTICE AND PLACE IT BEFORE THE FIRST PAGE OF THE STANDARD.
FSC MISC
Downloaded from http://www.everyspec.com
