INCH-POUND
MS8002D
w/AMENDMENT 1
09 September 2005
SUPERSEDING
MS8002D
24 September 2003
DETAIL SPECIFICATION SHEET
HOSE ASSEMBLY, POLYTETRAFLUOROETHYLENE, REUSABLE FITTINGS,
HIGH TEMPERATURE, MEDIUM PRESSURE, FLARE-TO-FLANGE
This specification is approved for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-25579.
Hose cut-off factor (HCOF) for assembly with class 1 fittings: See table l.
TABLE I.
HCOF for assembly with class 1 fittings. 1/
Fitting ends HCOF (size vs length) 3/ Style 2/
Corrosion
resistant steel
(CRES)
1 2 8 10 12 16 20 24
A MS27053 MS27054 2.16 2.47 2.51 2.91 3.13 3.47
B MS27053 MS27056 2.18 2.47 3.03 3.28 3.66 4.16
C MS27053 MS27058 2.14 2.46 3.05 3.35 3.78 4.34
MS27059 MS27056 3.04 D
MS27055 MS27056 3.00 3.95 4.12 4.64 5.25
MS27059 MS27058 3.00 E
MS27055 MS27058 2.99 3.97 4.19 4.76 5.43
MS27060 MS27058 2.52 F
MS27057 MS27058 2.82 3.84 4.10 4.68 5.36
MS27059 MS27054 3.02 G
MS27055 MS27054 3.00 3.43 3.75 4.11 4.56
MS27060 MS27054 2.54 H
MS27057 MS27054 2.83 3.30 3.66 4.03 4.49
MS27060 MS27056 2.56 J
MS27057 MS27056 2.83 3.82 4.03 4.56 5.18
1/ Class 1 fittings, styles A through J, are made from CRES.
2
/ For depiction of styles see figure 1.
3/ The HCOF is used in the following calculation to determine the hose length required to
produce an assembly of a specific size, style and length: Assembly length - HCOF = Hose
length. For example, the hose length required to produce an 25.50 inch length assembly of
size 10, style J is calculated as follows: 25.50 - 2.83 = 22.67.
AMSC N/A FSC 4720
Downloaded from http://www.everyspec.com
