INCH-POUND
MS8003D
w/AMENDMENT 1
09 September 2005
SUPERSEDING
MS8003D
24 September 2003
DETAIL SPECIFICATION SHEET
HOSE ASSEMBLY, POLYTETRAFLUOROETHYLENE, REUSABLE FITTINGS,
HIGH TEMPERATURE, MEDIUM PRESSURE, FLARELESS-TO-FLANGE
This specification is approved for use by all
Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-25579.
Hose cut-off factor (HCOF) for assembly with class 1 fittings: See table l.
TABLE I.
Hose cut-off factor (HCOF) for assembly with class 1 fittings. 1/
Fitting ends HCOF (size vs length) 3/ Style 2/
Corrosion
resistant steel
(CRES)
1 2 8 10 12 16 20 24
A MS27381 MS27054 2.39 2.74 2.78 3.19 3.41 3.88
B MS27381 MS27056 2.41 2.74 3.30 3.56 3.94 4.57
C MS27381 MS27058 2.37 2.73 3.32 3.63 4.06 4.75
MS27384 MS27056 3.20 D
MS27382 MS27056 3.19 4.13 4.31 4.83 5.53
MS27384 MS27058 3.16 E
MS27382 MS27058 3.18 4.15 4.38 4.95 5.71
MS27385 MS27058 2.52 F
MS27383 MS27058 2.82 3.84 4.10 4.68 5.36
MS27384 MS27054 3.18 G
MS27382 MS27054 3.19 3.61 3.94 4.30 4.84
MS27385 MS27054 2.54 H
MS27383 MS27054 2.83 3.30 3.66 4.03 4.49
MS27385 MS27056 2.56 J
MS27383 MS27056 2.83 3.82 4.03 4.56 5.18
1/ Class 1 fittings, styles A through J, are made from CRES.
2/ For depiction of styles see figure 1.
3/ The HCOF is used in the following calculation to determine the hose length required to produce
an assembly of a specific size, style and length: Assembly length - HCOF = Hose length. For
example, the hose length required to produce an 30.00 inch length assembly of size 20, style F is
calculated as follows: 30.00 - 4.68 = 25.32.
AMSC N/A FSC 4720
Downloaded from http://www.everyspec.com
