MIL-F-5591C
AMENDMENT 2
15 DECEMBER 1999
MILITARY SPECIFICAITON
FASTENERS, PANEL, NONSTRUCTURAL
This amendment forms a part of MIL-F-5591C, dated 20 JUNE 1999,
and is approved for use by all Departments and Agencies of the
Department of Defense.
Page 2
3.1 Delete and Substitute: “3.1 Qualification. The fastener
manufacturer shall be responsible for conducting qualification tests and
furnishing part drawings, certified qualification test reports (if required
by the purchaser) and test samples. The fasteners furnished under this
specification shall be produced using the same manufacturing methods as those
used to produce fasteners that have passed qualification tests. The
purchaser may apply any or all tests specified herein to any product
represented as meeting this specification, at any time, to verify
conformance.”
Page 7
3.7 Reidentify paragraph “3.7 Workmanship” as “3.8 Workmanship”.
Add paragraph “3.7 Identification of product”. The manufacturer’s
identification and code marking shall be marked on top of the stud head.
Marking may be formed by forging, stamping, or laser. Marking may be raised
or indented 0.010 inch maximum.”
Page 8
4.4.1 Delete and Substitute: “4.4.1 Qualification samples. Test
samples shall be of the same material and manufactured by the same method as
production parts. Samples for qualification shall consist of eight specimens
as shown on figure 2, eight specimens as shown on figure 4, one specimen as
shown on figure 4, mounted on sheets having a total thickness of 0.010 inch
less than the total nominal thickness specified on figure 4, and one as shown
on figure 3.”
AMSC N/A FSC 5325
DISTRIBUTION STATEMENT A. Approved for public release; distribution is
unlimited.
