W-F-?3975B
-29September 1982
Superseding
MIL-F-8?75A
15 May 1978
MILITARY SPECIFICA~ION
FASTENERS, BLIND, HIGH STRENGTH, INSTALLATION FORMED,
CORROSION RESISTANT STEEL, HEAT RESISTANT STEEL AND TITANIUM,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and
Agencies of the Department of Defenae.
1.
SCOPE
1.1
&!!l!S.
‘his specification covers installation
formed high strength, corrosion resistant, heat resistant steel and
titanium fasteners which can be installed from only one side of an
.asaembly.
1.2
Classification. Faateners furnished under this
specification shall be of the following types and classes:
Type I
- Pull Type - Positive Mechanically Locked (see 6.4)
Type 11 - Threaded - Self Locking (see 6.4)
Clasa 1 - 95 RSI Fsu, -Corrosion
Reeiatant Steel
Claas 2 - 75 RSI Fsu, Titanium
2.
APPLICABLE DOCUMENTS
2.1
Government documents.
and Heat
2.1.1
Specifications and standarda.
Unleea otherwise
specified.
the followinz specifications and standards of the iesue
listed in”that iesue of-th~ Department of Defense Index of !juecificationa
and Standards (DoDISS) specified in the solicitation,
of this specification to the sxcent specified herein.
SPECIFICATIONS
FEDEw
form a“ part
QQ-P-35
Passivation Treatment for Corrosion-Resisting Steel
QQ-P-416
Plating, Cadmium (Electrodeposited)
Beneficial comments (recommendations, additions,
deletlons) and any pertinent
data which may be of use in improving this document should be addressed
to: ~gineering Specifications and Standards Department (Code 93), Naval
Air Engineering Center, Lakehurst,
NJ 08733, by using the self-addressed
Standardization Document Improvement Proposal (DD Form 1426) appearing at the
end of this document or by letter.
Downloaded from http://www.everyspec.com
