AMSC N/A 1 of 9 FSC 5320
DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited.
MIL-F-8975B
AMENDMENT 4
7 DECEMBER 1998
SUPERSEDING
AMENDMENT 3
31 May 1994
MILITARY SPECIFICATION
FASTENER, BLIND, HIGH STRENGTH, INSTALLATION FORMED
CORROSION RESISTANT STEEL, HEAT RESISTANT STEEL AND TITANIUM
GENERAL SPECIFICATION FOR
This amendment forms a part of Military Specification MIL-F-8975, dated 29 September 1982, and is
approved for use by all departments and agencies of the Department of Defense
PAGE 1
Change paragraph 2.1 to the following:
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification.
This section does not include documents cited in other sections of this specification or recommended for
additional information or as examples. While every effort has been made to ensure the completeness of
this list, document users are cautioned that they must meet all specified requirements documents cited in
sections 3 and 4 of this specification, whether or not they are listed.
Replace paragraph 2.1.1 with the following:
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks
form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these
documents are those listed in the issue of the Department of Defense Index of Specifications and
Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
PAGE 2
Change the heading “MILITARY” to read “DEPARTMENT OF DEFENSE”
Remove MIL-I-6866 and title.
Remove MIL-L-8937 and title.
Remove MIL-STD-105 and title.
Remove MIL-STD-1312 and title.
Change the paragraph “(Copies of specifications, standards, drawings.....” to:
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available
from the Defense Automated Printing Service, 700 Robbins Avenue, building 4D, Philadelphia, PA
19111-5094.)
INCH-POUND
Downloaded from http://www.everyspec.com