IIimEl
DOD-P-24655
23 October 1985
MILITARY SPECIFICATION
PAINT, UNDERWATER HULL, ANTICORROSION
(METRIC)
This specification is approved for use by all Departments and Agencies of
the Department of I.)efense.
1.
SCOPE
1.1 Scope.
This specification covers anticorrosion coating systems for
application on
steel or aluminum underwater hull surfaces underneath Navy
antifouling coatings.
1.2 Classification.
Coating systems shall be of the following types,
classes and grades (see 6-2.1):
Type I -
Type 11 -
Type III -
Class 1 -
Class 2 –
Class 3 -
Class 4 -
Grade A -
Grade B -
Two component epoxy system.
Two component polyurethane system.
One component solvent evaporation system.
Curing range above 31 degrees Celsius (“C)
(87 degrees Fahrenheit (“F)).
Curing range 11 to 30”C (51 to 86°F).
Curing range 1 to 10”C (33 to 50”F).
Curing range below O“C (32°F).
Coatings with a solids content of 50 percent
by volume minimum.
Coatings with a solids content of 80 percent
by volume minimum.
2.
APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications and standards.
The following specifications and
standards form a part of this specification to the extent specified herein.
Unless otherwise specified,
the issues of these documents shall be those
listed in the issue of the Department of Defense Index of Specifications and
Standards (DoDISS) and supplement thereto, c~.tedin the solicitation.
Beneficial comments (recommendations, additions,
deletions) and any pertinent
data which may be
of use in improving this document should be addressed to:
Commander, Naval Sea Sys~ems Command, SEA 55Z3, Department of the Navy,
Washington,
IX 2U362-51OI by using the self-addressed Standardization Document
Impro\’ement
Proposal (DL)Form 1426) appearing at the end of this document or
by letter.
FSC 8010
DISTRIBUTION STATEMENT A Approved for public release; distrib~ltion unlimited
..——.
Downloaded from http://www.everyspec.com
