FF-P-395B
October 15, 1973
SUPERSEDING
Fed. Spec. FF-P-395A
January 10, 1966
FEDERAL SPECIFICATION
PIN, DRIVE, GUIDED AND PIN DRIVE, POWDER ACTUATED
(FASTENERS FOR POWDER ACTUATED AND HAND ACTUATED
FASTENING TOOLS)
This specification was approved by the Commissioner, Federal Supply Service,
General Services Administration, for the use of all Federal agencies.
1. SCOPE AND CLASSIFICATION
1.1 Scope. This specification covers threaded studs, drive pins, and eye
pins for powder actuated tools and hand actuated tools.
1.2 Classification. Fasteners covered by this specification shall be the
following types, classes and styles, as specified (see 6.2):
Types; each type describes fasteners for use with:
I - Direct-acting (gas driven, no piston) high velocity tools.
II - Indirect-acting (piston driven) low and medium velocity tools.
III - Hand driven tools.
IV - Special.
Classes; by fastener guide bore diameter (see 6.4):
1 - 0.251-0.261 inch (6.37-6.63 mm).
2 - .313- .330 inch (7.95-8.38 mm).
3 - .340- .345 inch (8.64-8.76 mm).
4 - .376- .390 inch (9.55-9.91 mm).
5 - .392- .400 inch (9.96-10.2 mm).
Styles; drive pins and studs for concrete and steel:
PC - Drive pin for concrete.
PS - Drive pin for steel.
SC - Threaded stud for concrete.
SS - Threaded stud for steel.
EP - Eye pin for concrete and steel.
2. APPLICABLE DOCUMENTS
2.1 The following documents, of the issues in effect on the date of
invitation for bids or request for proposal, form a part of this
specification to the extent specified herein:
Federal Specification:
Downloaded from http://www.everyspec.com
