*------------*
* INCH-POUND *
*------------*
GGG-C-2773
12 March 1992
SUPERSEDING
MIL-C-82069C
15 April 1985
FEDERAL SPECIFICATION
CYLINDER RECONDITIONING AND CORRECTION EQUIPMENT: PORTABLE
This specification is approved by the Commissioner, Federal
Supply Service, General Services Administration, for the use
of all Federal agencies.
1. SCOPE
1.1 Scope. This specification covers cylinder reconditioning and correction
equipment. The correction units are specifically for the cylinder walls of
internal combustion engines.
1.2 Classification. Cylinder reconditioning and correction equipment shall
be of the following classes, types, and sizes as specified (see 6.2).
Class 1 - Reamer, ridge, with cutting range to be no less than 1-1/2
inches and no greater than 5 inches
Type I - With supporting bracket
Type II - With interior cylinder wall-clamping mechanism
Class 2 - Hone, spring-loaded, cylinder glaze breaking
Size A - 3/4- to 2-inch cylinder diameter capacity range
Size B - 2- to 7-inch cylinder diameter capacity range
Class 3 - Hone, flexible brush type, cylinder glaze
breaking/reconditioning
*-----------------------------------------------------------------------------*
*Beneficial comments (recommendations, additions, deletions) and any pertinent*
*data which may be of use in improving this document should be addressed to: *
*Commanding Officer (Code 156), Naval Construction Battalion Center, Port *
*Hueneme, CA 93043-5000, by using the Standardization Document Improvement *
*Proposal (DD Form 1426) appearing at the end of this document or by letter. *
*-----------------------------------------------------------------------------*
FSC 5110
DISTRIBUTION STATEMENT A. Approved for public release; distribution is
unlimited.
Downloaded from http://www.everyspec.com
