*------------*
* INCH-POUND *
*------------*
GGG-C-2794
10 April 1992
-------------
SUPERSEDING
MIL-C-1258D
14 February 1983
FEDERAL SPECIFICATION
CUPS, OIL, LUBRICATING, AND OILERS, SELF-FEEDING
This specification is approved by the Commissioner, Federal
Supply Service, General Services Administration, for the use
of all Federal agencies.
1. SCOPE AND CLASSIFICATION
1.1 Scope. This specification covers oil cups used for lubricating wearing
parts of mechanical equipment.
1.2 Classification.
1.2.1 Types and styles. Oil cups are of the following types and styles, as
applicable, as specified (see 6.2 and 6.5):
Type A - Screw cap (see table I)
Type B - Spring cap (see table II)
Type C - Cylindrical slotted cap (see table III)
Type D - Hinged cap (see table IV)
Type F - With sight feed (see table V)
Type G - Ball valve (drive), straight (see table VI)
Style 1 - With flange (see figure 6)
Style 2 - Without flange (see figure 6)
Type H - Small elbow (see table VII)
*-----------------------------------------------------------------------------*
*Beneficial comments (recommendations, additions, deletions) and any pertinent*
*data which may be of use in improving this document should be addressed to: *
*Commanding Officer (Code 156), Naval Construction Battalion Center, Port *
*Hueneme, CA 93043-5000, by using the Standardization Document Improvement *
*Proposal (DD Form 1426) appearing at the end of this document or by letter. *
*-----------------------------------------------------------------------------*
FSC 4730
DISTRIBUTION STATEMENT A. Approved for public release; distribution is
unlimited.
Downloaded from http://www.everyspec.com