.
I
I
L-P-1183B
January 13, 1977
SUPERSEDING
‘r
I
i
)
I
Fed. Spec. L-P-1183A
~Uly 23, 1971
FEDERALSPECIFICATI(B?
PLASTICWLDING
MATERUL, ACRYX4XJITRILE-
BUTADZENE-STXRENE(ABS), RIGID
TMs specification wan apprmed by the Comimioner,
Federal Supply Service, General Services Admlniatra-
tion, for the use
of all Federal agencies.
1.
SCOPE
AND CLASSIFICATION
1.1 scope*
This specification covero
●crylonitrile-butedlene-atyrene
rigid themoplaatic materials suitable for injection or compression moldings
calendering, and extrusion.
1.2 Chmsification.
.
1.2.1 mea.
The acrylonitrile-butdiene-styrene materials shall be
of
the
following types, u specified (eee 6.1 and 6.2).
Type I -
Type 11 -
Type
III -
Type IV -
TypeV -
Type VI -
Lowest impact strength, high tensile streoa
●t yield
point.
Higher
impact and lower tensile ctress ●t yield point
than type 1.
Nighmt tenaiie 8tree8 ●t yield point.
Highest deflection temperature under load
Higher
iqmct strength than types I, 11, 111, - Iv,
and lowest tensile stress at yield point.
Highest impact strength, intemdiate temlle stress
●t
yield point.
2. APPLICABLEDOCUMNTS
2.1 The following docmnts of the ismee in effect on date of lnvi~tloa
for bids or request for proposal, fom a part of this specification to tie
extent specified herein.
Fsc 9330
‘-.
Downloaded from http://www.everyspec.com
