NOT MEASUREMENT
SENSITIVE
MMM-A-1617B
10 February 1995
SUPERSEDING
MMM-A-1617A
24 March 1987
FEDERAL SPECIFICATION
ADHESIVE, RUBBER BASE, GENERAL PURPOSE
The General Services Administration has authorized
the use of this federal specification by all Federal agencies.
1. SCOPE
1.1 Scope. This specification covers natural and synthetic rubber base
adhesives (see 6.1).
1.2 Classification. The elastomeric adhesives shall be of the following
types as specified (see 6.2b):
Type I - Natural rubber base, synthetic natural (polyisoprene),
styrene butadiene (SBR), reclaim, or combinations
thereof; non-oil resistant
Type II - Polychloroprene rubber base; oil-resistant
Type III - Butadiene acrylonitrile (Nitrile) rubber base, fuel
resistant
Beneficial comments (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document should be
addressed to: Commander, Systems Standardization, Code 4.1.11B120-3, Naval
Air Warfare Center Aircraft Division, Highway 547, Lakehurst, NJ 08733-5100,
by using the Standardization Document Improvement Proposal (DD Form 1426)
appearing at the end of this document or by letter.
AMSC N/A FSC 8040
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
2. APPLICABLE DOCUMENTS
2.1 Government documents.
* 2.1.1 Specifications, standards, and handbooks. The following
specifications, standards, and handbooks form a part of this document to the
extent specified herein. Unless otherwise specified, the issue of these
documents shall be those listed in the issue of the Department of Defense
Index of Specifications and Standards (DODISS) and supplement thereto, cited
Downloaded from http://www.everyspec.com
