I
QQ-A-2ooE/GEN
AMENDMENT 1
I
21 February 1983
FEDERAL SPECIFICATION
ALUMINUM ALLOY , BAR, ROO , SHAPES, STRUCTURAL SHAPES, TU8E ANO WIRE,
EXTRUDED; GENERAL SPECIFICATION FOR
This amendment which forms a part of QQ-A-200E/GEN, dated November 6,
1980 is approved by the Ass itant Administrator, Office of Personal
Property, General Services Administration for the use of all Federal
agencies.
Paragraph 1.2,
Paragraph 2.2,
“7XXX Series”
Paragraph 3.7,
illustrated by
PAGE 1
AOD:
“1.2.2 -.
Tubing shall be
as fol lows:
Type I -
Tubing extruded
defined’in 6.4.5.1.
Type II -
Tubing extruded
methods (see 6.4.5 .2).”
.
additionally classified
by the method
by other
,400, after “ASTM G34°:
“-72”; OELETE in title of ASTM G47:
PAGE 4
OELETE fourth line and SUBSTITUTE: “corrosion less than that
photograph B in figure 2 of ASTM G34-72”
Paragraph 3.9, AOO, after last line:
“[n addition to other markings
“soecified, type 1 tubes shall ha’~e the label
“TYPE 1“ applied on locations and
in a manner in accordance with FED- STO-184 (see 6.4.5.1 ).“
Paragraph 3.12, OELETE entire pdragraoh and SUBSTITUTE: “3.12 ~. when
specified, type I tube shall tiesuppi ied (see 6.2, 6.4.5 .1).”
Paragraph 3.13, OELETE, on third 1ine: “pipes, laPs and seams” and
SUBSTITUTE:
“internal voids and cavities, surface defects running [engthwise
and appearing as folded-over metal or crevices”
PAGE 5
Paragraph 4.2.1.1, INSERT, in third line after “heat-treated lot”: “or ~ots”
I
FSC 9530, 4710
9525, 9540
Downloaded from http://www.everyspec.com
