RR-F-191/1D
14 May 1990
-----------
SUPERCEDING
RR-F-191/1C
July 22, 1981
FEDERAL SPECIFICATION SHEET
FENCING, WIRE AND POST METAL (CHAIN-LINK FENCE FABRIC)
(DETAIL SPECIFICATION)
This Federal Specification is approved by the Commissioner, Federal
Supply Service, General Services Administration, for the use of all
Federal agencies.
(This specification forms a part of the latest issue of Federal
Specification RR-F-191K/GEN).
1. SCOPE AND CLASSIFICATION
1.1 Scope. This specification covers requirements for chain-link fabric.
1.2 Classification. Chain-link fabric will be of the following types,
mesh sizes, wire gage size, and fabric height as specified (see 6.1):
Type I - Zinc-coated steel.
Type II - Aluminum-coated steel.
Type III - Aluminum alloy.
Type IV - Polyvinyl chloride (PVC) coated over zinc or aluminum
coated steel.
Mesh size in inches:
1 inch (9 and 11 wire gage size only).
1-3/4 inch (all wire gage sizes).
2 inch (all wire gage sizes).
2-1/8 inch (all wire gage sizes).
*-----------------------------------------------------------------------------*
*Beneficial comments (recommendations, additions, deletions) and any pertinent*
*data which may be of use in improving this document should be addressed to: *
*Commanding Officer (Code 156), Naval Construction Battalion Center, Port *
*Hueneme, CA 93043-5000, by using the self-addressed Standardization *
*Document Improvement Proposal (DD Form 1426) appearing at the end of this *
*document or by letter. *
*-----------------------------------------------------------------------------*
FSC 5660
DISTRIBUTION STATEMENT A. Approved for public release; distribution is
unlimited.
Downloaded from http://www.everyspec.com
