●
[Inch-Pound]
FED-STD 832
September 1,2002
FEDERAL STANDARD
CONSTRUCTION METHODS AND MATERIALS FOR VAULTS
The General Services Administration has authorized the use of this federal standard by all federal
agencies.
1. SCOPE. Thisdocment establishes minimmconstmction requirements forhighsecmity
vaults for storage of classified information and weapons.
2. REFERENCED DOCUMENTS.
2.1 Government Publications. The following documents form a part of this Federal Standard to
the extent specified herein.
Federal Specifications:
AA-V-2737 – Modular Vault Systems
FF-L-2740 – Locks, Combination
AA-D-600 – Door, Vault, Security
Single copies of this Specification and other Federal Specifications are available from: General
Services Adrnkistration, Federal Supply Service, Specifications Section (3FP-E), Suite 8100,
470 East L’Enfant Plaza, SW, Washington, DC 20407, Tel - (202)619-8925.
2.2 Other publications. The following document forms a part of this Federal Standard to the “‘
extent specified herein.
Americiur Concrete Institute:
Standard ACI318 – (Building Code Requirement for Reinforced Concrete)
(Application for copies should be addressed to P.O Box 9094; Farmington Hills, MI 48333-
9094,)
3. DEFINITIONS. Not Applicable.
Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any
other data which may improve this document should be sent to: General Services
Administration, Federal Supply Service, National Furniture Center, Engineering Division
(3FNE-CO), Washington, DC 20406.
FSC711O
Downloaded from http://www.everyspec.com
