KIL-V-24630(SH)
19 March 1984
MILITARY SPECIFICATION
:
...-
?
VALVES, CHECK, IN-LINE, FOR HYDRAULIC
FLUID AND LUBRICATING OIL FLUID
This specification is approved for use by the Naval Sea Systems Command,
Department of the Navy, and is available for use by all Departments and
Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope.
This specification covers the requirements for in-line check
valves for use in hydraulic fluid and lubricating oil fluid systems of Naval
ships operating up to a maximum pressure of 3000 pounds per square inch (lb/in2).
1.2 Classification.
In-1ine check valve assemblies shall be designated by
standard part numbers as follows and as specified (see 6.2.1):
12++
Prefix
Specification
Applicable Dash number
to
number specification to represent
indicate.
sheet number
dimension and
a military flow requirement
specification
(see specification
sheets for dash
numbers)
2. APPLICABLZ DOCUMENTS
2.1 Government documents.
2.1.1 Specifications and stanciards.
Unless otherwise specified, the
following specifications and standards of the issue listed in that issue of the
Department of Defense Index of Specifications and Standards (DoDISS) specified
in the solicitation form a part of this specification to the extent specified
herein.
Beneficial comments (recommendations,
additions, deletions) and any pertinent
data which may be of use in improving this document should be addressed to:
Commander, Naval Sca Systems Command, SEA
5523, Department of the Navy,
Washington, DC 20362 by using the self-addressed Standardization Document
Improvement 2roposal (DD Form
1426) appearing at the end of this document
or by letter.
FSC 4a20
