AMSC N/A FSC 5905
Comments, suggestions, or questions on this document should be addressed to: Defense Supply Center,
Columbus, ATTN: DSCC-VAT, Post Office Box 3990, Columbus, Ohio 43216-5000 or by email Resistor@dla.mil
.
Since contact information can change, you may want to verify the currency of this address information using the
SSIST Online database at http://www.dodssp.daps.mil.
This document has been republished with active hyperlinks. INCH-POUND
No other changes have been made. MIL-PRF-12934K
14 April 2004
SUPERSEDING
MIL-PRF-12934J
1 February 1999
PERFORMANCE SPECIFICATION
RESISTOR, VARIABLE, WIRE WOUND, PRECISION
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope
This specification covers the general requirements for precision, wire-wound, variable resistors whose
electrical output (in terms of percent of applied voltage) are linear or nonlinear with respects to the angular position of
the shaft. This specification includes requirements for linear and nonlinear, single turn and multiturn, single-section
(cup) and multisection variable resistors. These resistors are capable of full-load operation at maximum ambient
temperatures of 70
O
C and 85
O
C and are suitable for continuous operation, when properly derated, to maximum
temperatures of 125
O
C and 150
O
C (see 3.1, 6.2, and figure 10). This specification includes requirements for category
I, category II, and category III precision resistors as described herein (see 3.2).
1.2 Classification
:
1.2.1 Part or Identifying Number (PIN)
.
a. Category I resistors: The PIN completely describes the category I resistors of this specification.
Single-section (cup) resistors
RR0900 A 2 A 7 J 103
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
Style
(1.2.1.1)
Function
and shaft
length
(1.2.1.2)
Class
and
center
tap
(1.2.1.3)
Resistance
temperature
characteristic
(1.2.1.4)
Rotational life
characteristic
(1.2.1.5)
Function
conformity
tolerance and
resistance
tolerance
characteristic
(1.2.1.6)
Resistance
(1.2.1.7)
b. Category II resistors: The PIN of 1.2.1 is modified by changes in style designation (see 1.2.1.1), when used
to describe a category II resistor. The PIN in this case does not fully describe the individual resistor. The
resistor in this case is completely identified only by the addition of a drawing number in the marking (see
3.34 and 6.2.2).
RR09XXA2A7J103
Downloaded from http://www.everyspec.com
