NOTE: The document identifier and heading has been
IINCH-POUND1
changed on this page to reflect that this is a performance
,
specification, There arenoother changes to this document.
MIL-PRF-14409D
The document identifier on subsequent pages has not been
AMENDMENT 6
changed, but will be changed the next time this document is
3 Mav 1994
revised,
SUPERSEDING
AMENDMENT 5
8 July 1993
PERFORMANCE SPECIFICATION
VARIABLE (PISTON TYPE, TUBULAR TRIMMER),
CAPACITORS,
GENERAL’SPECIFICATION FOR
This amendment forms part of MIL-PRF-14409D, dated 15 April 1975, and is
approved fOr use by all Departments and Agencies of the Department of Defense,
PAGE 1
TA LEl, add:
(I
“
K— -55to +125 O*75 i.16%of maximum rated value or
.03pF(whichever isgreater). “
PAGE 2
. 2.1, STANDARDS, MILITARY: Delete ''MIL-STD-l 05-Sampling Procedures and Tables forlnspection
by Attributes.”
PAGE 3
3.6, delete in its entirety
PAGE 5
3.26, 1inetwm Delete’’source codes’’ andsubstitutl otcodesdas’a
3.27.1, delete and substitute
“3.27.1 Solderabilitv. ~eresoldeting isemployed inthemnstmction ofcapacitom, only fluxes with
low corrosive properties shall be used, unless it can be shown that corrosive elements have been
satisfactorily removed after soldering. Allexcess flux andsolder shallberemoved. Electrical
connections shall beelectrically continuous aRer solder and, where possible, mechanically secure
before soldering.”
PAGE 7
TABLE 11,first column: Group l,delete’’Burn-in’’ testand all related data
AMSC NIA
1 of4
FSC 5910
DISTRIBUTION STATEMENTA. Approved forpublic release; distribution is unlimited.
Downloaded from http://www.everyspec.com
