MIL-STD-188-1OO
NOTICE 2
1 June 1976
.
MILITARY STANDARD
COIWON LONG HAUL AND TACTJCAL
COMMUNICATION SYSTEM TECHNICAL STANDARDS
TO ALL HOLDERS OF MIL-STD-I88-1OO:
1. The following changes should be made in pen and ink:
.
Page 3, paragraph 2.2 Military Standards, delete MIL-STD-188-
300 ;nd its title, and replace with the following:
MIL-STD-188-114
Electrical Characteristics of Digital Interface Circuits, 24 March 1976.
b.
Page 25, paragraph 4.3.1.3 Low Level Digital Interfaces,
add: “As specified in MIL-STO-188-114.”
c.
Delete subparagraphs 4.3.1 .3.1 on page 25 through 4.3.1.3.4.10
on page 31, including Figure 4.3-2 on page 26, Figure 4.3-3 on page 28,
and Figure 4.3-4 on page 29.
d.
Page 33, paragraph 4.3.1.5 Logical and Siqnal Sense for Binary
Slcanals, change the first sentence to read: “For data or timing
circuits, the signal voltage with respect to signal ground shall be
negative to repre .nt marking and positive to represent spacing.”
In the table just below the above aragraph, in first line
!
chan~e “Positive (+)” to read “Negative (- .“and “Negative (-)” to
read “Positive (+)”.
In the fourth line change “On” to read “Off”,
and “Off” to read “On”.
2. Refer to pages vi and vii of Table of Contents and delete all
reference to paragraphs 4.3.1 .3.1 through 4.3.1.3.4.10.
3. RETAIN THIS NOTICE PAGE ANO INSERT BEFORE THE TABLE OF CONTENTS.
4. Holders of MIL-STD-188-1OO will verifv that the above changes
have been made. This notice will be re4
Thfs issuance is a separate publ
retatned by stocking points unti
revised or cance?led.
~~ned as a check sheet;
cation Each notice is to be
the Pllitary Standard is completely
FSC SLHC/TCTS
Downloaded from http://www.everyspec.com
