INCH-POUND
MIL-PRF-22684F
13 February 2006
SUPERSEDING
MIL-PRF-22684E
24 September 1999
PERFORMANCE SPECIFICATION
RESISTORS, FIXED, FILM (INSULATED)
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope
. This specification covers the general requirements for insulated, film, fixed resistors of 2- and 5-
percent resistance tolerance. These resistors are capable of full-load operation at an ambient temperature of 70°C
and have a resistance-temperature characteristic of +
200 parts per million per degree Celsius (ppm/°C), (see 6.1).
1.2 Classification
.
1.2.1 Part or Identifying Number (PIN)
. Resistors specified herein are identified by the PIN which consists of the
basic number, associated specification, and a coded dash number.
M22684/08- 1001
│
│
│
│
Basic and associated
specification number
Coded dash number
(see 1.2.1.1)
1.2.1.1 Coded dash number. The coded dash number is a coded value which identifies the resistance value,
resistance tolerance, and the terminal (see 3.1).
2. APPLICABLE DOCUMENTS
* 2.1 General
. The documents listed in this section are specified in sections 3, 4, and 5 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements documents cited in sections 3, 4, and 5 of this
specification, whether or not they are listed.
AMSC N/A FSC 5905
Comments, suggestions, or questions on this document should be addressed to: Defense Supply
Center, Columbus, ATTN: DSCC-VAT, Post Office Box 3990, Columbus, Ohio 43218-3990, or
emailed to resistor@dla.mil
. Since contact information can change, you may want to verify the
currency of this address information using the ASSIST Online database at http://assist.daps.dla.mil.
Downloaded from http://www.everyspec.com
