DOD-S-63543
19 February 1982
MILITARY SPECIFICATION
STUD AND ROD, THREADED, METRIC,
GENERAL SPECIFICATtON FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1
*“
This specification covers piain type studs (iength up to
400 mm), and rods (iength greater than 4fin mm),
which are headiess external Iy
threaded fasteners the entire iength of which has the same nominal threaded
diameter.
2.
APPLiCAi3LE DOCUMENTS
2.1
@vernment documents.
2.1.1
Specifications, standards, and handbooks. Unless otherwise
specified, the following specifications, standards, and handbooks of the issue
iisted in that issue of the Departmnt of Defense index of Specifications and
Standards (DODiSS) specified in the solicitation, form a part of this
specification to the
SPECIFICATIONS
FEDERAL
QQ-B-637 -
QQ-N-281 -
QQ-Z-325 -
QQ-P-416 -
PPP-H-1581 -
extent specified herein.
Brass, Naval, Rod, Wire, Shapes, Forgings, end Flat
Products with Finished Edges (9ar, Flat Wire and Strip)
Nickei-Copper AiJoy Bar, Rod, Plate, Sheet, Strip, Wire,
Forgings, and Structural and Special Shaped Sections
Zinc Coating, Eiectrodeposited
Plating, Cadmium (E iectrodeposlted)
Hardware (Fasteners and Reiated items), Packaging and
Packing for Shipment and Storage of
Beneficial comments (recommendations, additions,
deiet,lons) and any pertinent
data which may be of use in improving this document should be addressed to:
Commander, US Army Armament Research and Development Command, ATTN: DRDAR-
TST-S, i30ver, NJ 07301, by using the self-addressed Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or
by letter.
FSC 5307
Downloaded from http://www.everyspec.com
