e. Disconnect slave hose female
coupling half (6) from valve
outlet coupling half (11).
f. Remove protective covering and
connect return hose coupling
half (10) to valve outlet coupling
half (11).
g. Pull on return hose to make sure
connection is locked.
h. Wipe up any spilled hydraulic
fluid.
e. Remove protective covering and
connect inlet hose coupling half (8)
to pump output coupling half (9).
f. Pull on inlet hose to make sure
connection is locked.
g. Wipe up any spilled hydraulic fluid.
8. On operating vehicle:
a. Disconnect slave hose male
coupling half (7) from return
hose coupling half (10).
b. Remove protective covering and
connect return hose coupling
half (10) to valve outlet coupling
half (11).
c. Pull on return hose to make sure
connection is locked.
d. Disconnect slave hose female
coupling half (6) from pump
outlet male coupling half (9).
9
9. Clean both slave hoses using
solvent.
10. Dry hoses thoroughly.
11. Install dust caps (12) on slave
hoses.
12. Stow a slave hose in the left rear
fender stowage box (5) of each
vehicle.
10
GTA 05-04-037
HYDRAULIC
SLAVING PROCEDURE
FOR ARMORED
VEHICLE LAUNCHED
BRIDGE
lAW TM 5-5420-226-10
DISTRIBUTION RESTRICTION: Approved for
public release; distribution us unlimited.
DISTRIBUTION: U.S. Army training and audio-
visual support centers (TASCs).
HEADQUARTERS, DEPARTMENT
OF THE ARMY
